Nexus Pneumatics Private Limited

The straight line action toggle clamps design uses a straight-line or push/pull, Toggle

clamping action. The push/pull handle is easy to operate & moves the plungers of the

clamp in and out along its axis. Most of these clamps can be locked in two positions,

allowing you to use them as either push or pull clamps. These clamps are manufactured

in a variety of models to accommodate a wide range of load ratings.(45 kgs - 4,500 kgs)

Pull Action Clamps : (PAH-Series)

• Steel-Smith's Pull Action Clamps are designed for sealing chambers, doors, mould closures
• or other such applications requiring closure mechanisms. The handle can be moved to place
• the clamping U - Bolt Bar hook around the opposing latch & pull down to reach the lock
• position. The threaded hook or U-bolt type bar offer an adjustment feature. The clamps

These clamps are the air powered version of the manual H.V. Series. They comprise

of a very strong  and rugged toggle mechanism actuated by a double acting cylinder.

The clamping arm is provided with the clamp and can be welded at any desired

angle to suit the individual requirement of work pieces. These clamps carry the

‘Over Centre Toggle Lock’ principle for maximum safety as they remain in locked

condition even in case of air failure. The  clamps  have almost all the features of the

manual H. V. Series clamps. These clamps are available in three sizes off  the  shelf.

Horizontal Hold Down Action :(H 235 -Series) Toggle Clamp

• The holding action in these types of Toggle Clamps is same as VTC-Series clamp.
• The outstanding characteristic is the low height design. Unlike the handle & the
• clamping bar of the VTC-Series, these of the H-Series clamps move in opposite
• be solid bar, U shaped or fixed hole type.

As the name implies clamps of this type hold the work piece with a

downward clamping action. These clamps are manufactured with a holding capacity up to

o 3000 kgs. The clamping exhibits a minimum of 90 opening angle giving full clearance for

loading & unloading of workpiece. Clamping arm can be solid bar, U shaped or fixed hole

to suit individual requirements.